- All Debates
- Popular Debates
- Active Debates
- New Debates
- Open Challenge Debates
- My Challenge Debates
- Accepted Challenges
- Debate Communities
- Argument Waterfall
- New People
- People by Points
Well If you have better things to do, and dont care about the bible prophecy than you dont need to post anything on here. The Question is what if...And you responded with: "I'm Atheist, So I dont care and it wont happen because I am atheist" So please, leave this discussion to the people who DO care. Hope I didn't come off like a jerk though. No hard feelings? haha
Holy piss man.... Let me break it down to you so you can understand.
Stanly Meyers supposed car split water into hydrogen and oxygen, and then performed electrolysis
Electrolysis is what splits the Hydrogen and oxygen. Why would he perform electrolysis after the Hydrogen and Oxygen were split.
Due to covalent bonding between an Oxygen atom and two hydrogen Atoms in H20, The oxygen atom is unstable and results in a negative charge. The hydrogen atoms are then positive. If you set up two electronic fields, one positve and one negative, you can pull the molecule apart creating oxygen and hydrogen molecules and burn the hydrogen. Unfortunatly this alone is not very economic but Stan Meyers found a solution.
He created a circuit board called the voltage intensifier which lowers the amps and increases the voltage. All this stuff I mentioned is not quite the same as his injector. His injector is a total different thing. But it seemed you didn't fully understand this and thats why I ask you to do your homework. So please visit this webstite : www.waterfuelcell.org watch the two lecture videos...you might actually learn something. Be sure to watch the video on the right first because it is part 1 of the lecture. Part 2 talks mostly about the voltage intensifier.
Ha you are so stupid it's not that funny..... Im Not talking about the hydrogen fuel cell. Im talking about an injector created my STANLEY MEYERS. THIS IS NOT THE SAME AS THE FUEL CELL. This is run purely by water, and does all the things I have said, Not pure Hydrogen like in your video. The injector is not used anywhere either. After Stanley Meyers died, nobody has been able to create the injector based off his schematics. And I dont think I'm going to mess with nuclear fission/fussion. Haha, that would be bad. But now you know ;)
It's a lot more complicated actually. Its like the fuel cell but the plates switch polarities very quickly back and forth, causing the molecules to get excited and turning it into a steam before seperating it into H and O. Then, there is an electron collector that pulls the electrons of the H and O making it unstable so it decays and the energy from the nuclear fisson (or fusion) actually powers the engine or something. It's crazy
I mean water powered engine as in splitting water molecules into hydrogen and oxygen through electrolysis then burning the hydrogen to drive the pistons. I believe that is cold fusion that you referred to though. It is possible. What I was meant by the question, is not whether it is possible or not, but whether anyone would be able to mass produce it with these over powering oil companies.
I'm not saying the water is inexpensive. I see what you mean, but to an extent it can cost much much less.
first, If you were to make the engine yourself It would be pretty cheap, but you would have to have the knowledge. Which, if you did enough research on the internet and some dedicated time would be do-able.
Second, Stan Meyers invented an injector that goes inplace of the spark plug, and with a little clean up of the engine, and this injector, you can easily convert a normal combustible engine into a water powered engine. this would probably cost around $300 or so. Unfortunatly nobody knows how to make it and Stan Meyers is dead. The pattens with scematics are available on the internet, and the patten has timed out. So it only takes someone capable of understanding his scematics and making it, and there are plenty of well qualified scientists in this world.